Short answer: a last look, not a new inspection.
Real answer: The final walkthrough is the buyer’s last look at the home before closing. It confirms the home is in the same condition as when the offer was accepted. It also confirms agreed repairs are done, and the systems and included appliances still work. In Washington, the standard contract (NWMLS Form 21) gives the buyer the right to walk through within 5 days of closing, counted in business days. The seller must be fully moved out by 9 p.m. on the possession date.
Final walkthrough planner
Your walkthrough window, the best day, and what to do before it
Pick your side and your closing date. The window counts back in business days and skips Washington holidays, the way Form 21 does. Nothing you enter leaves this page.
Your window, day by day
Your checklist
A planning aid, not legal advice. Rules from NWMLS Form 21 (Rev. 2/26) General Terms c, f and l, Form 22D and Form 35; RCW 1.16.050, 19.27.530 and 43.44.110; 12 CFR 1026.19(f)(2); Fannie Mae Selling Guide B3-4.1-02. Your contract and addenda control, and a closing can also move when the county recording office is closed. For your situation, talk to your agent or a real estate attorney.
I schedule every walkthrough two business days before closing. That leaves room to fix what turns up. It’s also late enough to catch what happens in the last week. A stager’s mover dings a door, a pipe springs a leak, or a box of paint stays behind in the crawlspace. After closing, the same problem is between the new owner and the old one.
Same thing, other names: final walk-through, final walk through, pre-closing walkthrough, or the final inspection before closing (it isn’t an inspection). Form 21 calls it the buyer’s right to “walk through the Property.”
The rule
What Washington’s contract says about the final walkthrough
Five promises sit in one paragraph of Form 21, General Term f, and the walkthrough exists to check them. The seller keeps the home in its present condition, normal wear and tear excepted, until the buyer gets possession. If a system or an included appliance stops working before closing, the seller repairs or replaces it with one of at least equal quality.
Form 21, General Term f, in five promises
Same condition
Present condition, normal wear and tear excepted, until possession.Working systems
Plumbing, heat, electrical and included items repaired or replaced, at least equal quality.Walk-through right
Within 5 days of closing, to verify the above.Keys and codes
Keys, garage remotes and access codes on closing or possession, whichever comes first.Possession
9:00 p.m. on the possession date. The seller and their things are out.Keys, possession and included items
The buyer may walk through within 5 days of closing to verify that. Keys, garage remotes and access codes go to the buyer on the closing date or the possession date, whichever comes first. The buyer is entitled to possession at 9 p.m. on the possession date. Included items are spelled out in General Term c and Specific Term 5. They are built-in appliances, window treatments, lighting fixtures, plants in the ground, and the remotes and access permissions that run them.
Timing
When the walkthrough happens: the 5-business-day window
Timeframe Within the 5 business days before closing. I book it 2 business days out.
Form 21 counts any period of 5 days or less without weekends or Washington legal holidays, and counts backward from closing starting the day before. So “within 5 days of closing” means the 5 business days before the closing date, plus closing day itself. Around Thanksgiving, that window can start a week and a half before closing.
Closing set for Friday, November 27, 2026
Why two business days out
In Washington, closing means the deed records and the seller’s money is available, usually mid-afternoon. Buyers sign a day or more before that at escrow. So I put the walkthrough two business days out. That’s after the move-out trucks and before anyone signs, with time left to ask for a fix or a short extension. It takes 20 to 45 minutes in a typical house.
Owners moving out
For the owner moving out: what stays, what goes
Most walkthrough problems I see start with an honest mix-up about what conveys. The rule is simple: anything attached to the house stays unless the contract says otherwise. That includes the TV wall mount, curtain rods and blinds, light fixtures, the garage door opener and its remotes, and plants in the ground. Spare parts made for the house, like extra custom-size doors or the matching tile, stay too.
- 1TV wall mount: Stays; it’s attached
- 2Blinds and rods: Stay; window treatments are included
- 3Ceiling light: Stays; installed fixture
- 4Picture-hanging anchors: Stay; patching is a separate agreement
- 5Sofa and rug: Go; personal property
- 6Floor lamp: Goes; it plugs in
- 7Stager’s string lights: Go; they belong to the stager
- 8Paint cans: Stay only in colors on the walls
What goes with the seller
Personal property goes: furniture, rugs, the stager’s string lights, the garden hose on a cart, leftover paint in colors no longer on the walls. If a buyer wants something left behind, or a seller wants to take a fixture, it goes into a written addendum before closing. A mounted TV bracket removed without one is a contract problem, not a favor.
Sellers
For sellers: how to leave the house for the walkthrough
Be out, not almost out. Possession passes at 9 p.m. on the possession date, which is usually closing day. The walkthrough before that should show the house as the buyer will get it. A crawlspace, attic, shed or storage unit still holding boxes is the most common miss I see.
Keys and smart devices
Leave everything that opens the house in one place, and say where. I ask sellers to put keys, garage remotes, mailbox keys, fobs and alarm codes in one kitchen drawer. Then I photograph the drawer and send it to the buyer’s agent three days before closing. Release smart locks, video doorbells and thermostats from your accounts so the buyer can set them up the night they move in.
Alarms and cleaning
Washington adds one legal item. An owner-occupied house sold since 2009 needs carbon monoxide alarms before anyone moves in. Any dwelling sold since July 1, 2019 needs at least one smoke detector. Clean it as you’d want to find it. If the contract includes Form 22D’s cleaning clause, interiors must be cleaned and trash removed before possession.
Out by possession
House
- Crawlspace, attic and shed empty
- Yard debris and hoses gone
- Garage opener remotes in the drawer
Building items
Condo
- Building fobs and garage clicker
- Storage unit and bike cage emptied
- Move-out elevator booked
Shared parts
Townhome
- Mailbox and common-door keys
- Parking spot cleared
- HOA move-out rules met
How I plan a seller’s move-out week, step by step, is in the seller guide (clients).
Buyers
For buyers: what to check at the final walkthrough
Walk it in a loop, top to bottom, with the contract and the inspection response in hand. You’re checking three things: nothing new is broken, the agreed repairs are done, and what was supposed to stay is still there. Run the water, the heat, every included appliance and the garage door. Look up at ceilings under bathrooms for new stains, and at the floors where furniture moved out.
- 1Front door: Keys, locks, doorbell
- 2Kitchen: Range, dishwasher, fridge, disposal, faucets
- 3Living areas: Walls, floors where furniture sat, window treatments
- 4Bathroom: Run water, flush, look for drips
- 5Bedrooms: Windows open and lock, closets empty
- 6Second bath: Same checks; new stains on any ceiling below a bath mean a leak
- 7Laundry and mechanicals: Washer, dryer, heat on, water heater
- 8Garage and outside: Opener, remotes, yard cleared
Photos and receipts
Bring your phone charged. A photo of anything that looks different, taken before you sign, is worth more than a memory of it a week later. If repairs came with receipts, match them to the work.
Condition
Normal wear and tear vs. a real problem
Form 21 lets the house age a little between offer and closing; it doesn’t let it get damaged. Light scuffs, small nail holes and a worn path in the carpet are wear and tear. Moving-day damage, a new leak or a dead appliance are not.
Normal wear and tear
- Scuffs and small nicks from moving
- Small nail and anchor holes
- Light carpet wear in walkways
- Paint touch-ups that don’t quite match
- Dust where furniture stood
Raise it before closing
- A new water stain or active leak
- A broken window or door
- Gouged floors or holes in walls
- An included appliance or system that stopped working
- A missing fixture, blind or remote
- Belongings or trash left behind
Problems
If something is wrong at the final walkthrough
Stay calm and write it down. Photograph it, tell your agent the same day, and compare it with what the contract promised. Most problems I see end one of three ways. The seller fixes it before closing, the seller gives a credit at closing, or both sides sign a short extension so it can be fixed.
- Step 1DocumentPhotos and a list, before you sign anything
- Step 2Call your agentSame day; the listing agent hears it from them
- Step 3Check the contractForm 21 General Term f, Form 35R repairs, included items
- Step 4Pick a pathFix before closing, credit with the lender’s OK, or a short extension
- Step 5Put it in writingAn addendum signed by both sides
Most a seller can credit on a $1,350,000 home (Fannie Mae, primary home)
Credits when there’s a loan
A credit isn’t automatic when there’s a loan. Lenders cap what a seller can contribute. Fannie Mae allows 3 to 9% of the price for a primary home, depending on the down payment. Those dollars can’t go toward the down payment. A credit also changes the closing numbers, so the lender sends a corrected Closing Disclosure. It does not restart the federal 3-day wait; the CFPB’s own example is a dishwasher found broken at the walk-through and a $500 seller credit.
Walking away
Walking away is rare and serious. Say the home is materially different and the seller won’t make it right. That’s a question for your agent and a real estate attorney, not a decision to make in the driveway. What to ask for in your deal, and how, is in the buyer guide (clients).
Other timelines
Rent-backs, early move-ins and new construction
When possession doesn’t happen at closing, the walkthrough splits in two. With a seller rent-back (NWMLS Form 65B) the buyer walks through before closing, then again when the seller moves out. The rental agreement covers condition and the deposit. With an early move-in (Form 65A) the buyer takes the house before closing, so the walkthrough is really a move-in check. Both sides call their insurance companies either way.
Standard
- Walkthrough
- Closing
- Possession 9 p.m.
Seller rent-back, Form 65B
- Walkthrough
- Closing
- Seller rents
- Move-out walk
Early move-in, Form 65A
- Move-in check
- Buyer rents
- Closing
New construction
On new construction, the builder’s orientation or punch-list walk is a different thing from the final walkthrough. It comes earlier and is about finishing the house; the final walkthrough is about the house not changing.
FAQ
Frequently asked questions about the final walkthrough
Does the seller come to the final walkthrough?
Usually not. The buyer and the buyer’s agent go. The seller is moved out or out for the hour, and the listing agent hears about anything that comes up.
Can a seller refuse a final walkthrough?
Not under Form 21. The buyer has the right to walk through within 5 days of closing. A seller can ask that it happen at a reasonable time and that the buyer not test, measure or open walls.
How long does a final walkthrough take?
Twenty to 45 minutes for most Seattle houses and condos. Longer if there were many repairs to check.
How many days before closing is the final walkthrough?
In Washington, within 5 business days before closing. I schedule it 2 business days out.
Can the buyer do it a week or more early?
Not as the contract’s walkthrough. Earlier visits, to measure for furniture or baby gates, need the seller’s written permission.
Is the final walkthrough an inspection?
No. The inspection is over. The walkthrough checks that nothing changed and that agreed repairs are done; it isn’t a chance to renegotiate.
Can a buyer back out after the final walkthrough?
Only if the seller breached the contract and won’t cure it, and that’s a question for an attorney. Backing out for any other reason risks the earnest money.
What if the seller leaves things behind?
Ask them to remove them before closing. If Form 22D’s personal property clause is in the contract, anything left after the possession date becomes the buyer’s to keep or dispose of.
Who pays to clean the house?
The seller should leave it clean; Form 22D’s cleaning clause makes that a written term when it’s checked. Many buyers book their own move-in cleaning anyway.
What if something breaks after the walkthrough but before closing?
The seller’s duty to maintain the house runs until the buyer gets possession, so tell your agent right away.
Does a condo walkthrough differ?
Yes: check the building fobs, garage access, storage unit and mailbox key, and the building’s move-out rules.
The bottom line
The final walkthrough is a short, calm look that protects both sides. The seller proves the house is as promised, and the buyer confirms it before the money moves. Pack early, leave the keys in one place, and walk it two business days out.
Before and after the walkthrough: the under-contract to-do list, moving day and the 9 p.m. possession time, mailbox keys and the move-in address checklist, resetting smart locks.
Sources
- NWMLS Form 21, Residential Purchase and Sale Agreement, General Terms c, f and l; Form 22D Optional Clauses (cleaning, personal property); Form 35 paragraph 7 (repairs), Rev. 2/26
- RCW 1.16.050, Legal holidays, Washington State Legislature
- RCW 19.27.530, Carbon monoxide alarms, Washington State Legislature
- RCW 43.44.110, Smoke detection devices in dwelling units, Washington State Legislature
- 12 CFR 1026.19(f)(2), Subsequent changes, with the walk-through example, Consumer Financial Protection Bureau
- Selling Guide B3-4.1-02, Interested Party Contributions, Fannie Mae, May 7, 2025